A bit of Easter Lathe work
2 posters
48-84 :: Your first category :: 66-84
Page 1 of 1
A bit of Easter Lathe work
Needed an axle spacer, smaller ID than the stock ones I had...
Had a blank piece of aluminum, so started by milling it down to just under 1" OD
Then drilled it out to 5/8" ID
Fit it, looks good so far...we shall see once I run it...this is on the 45
Had a blank piece of aluminum, so started by milling it down to just under 1" OD
Then drilled it out to 5/8" ID
Fit it, looks good so far...we shall see once I run it...this is on the 45
sunnydog- Posts : 2053
Join date : 2012-10-28
Age : 55
Location : Akimbo Alogo
Re: A bit of Easter Lathe work
Nice spacer and chamfered for the bearing contact.
Dennman- Posts : 1446
Join date : 2012-10-31
Age : 75
Location : Courtenay
Similar topics
» Got the lathe rewired and lit
» work if you want it
» after a lengthy pause...................
» After a hard day's work
» chat box it does work
» work if you want it
» after a lengthy pause...................
» After a hard day's work
» chat box it does work
48-84 :: Your first category :: 66-84
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|